42
Projector
Ch
apt
er 1 U
s
e
r G
u
id
e
Change Projector Function
Changing the Current FUNCTION selection (F1 to F20) is
done using Change FUNCTION on the PROJECTOR
CONTROL screen. Functions can be used to recall stored
settings which affect the projector setup. Each
FUNCTION configuration is set using the SRX
Controller
1
application and is set to optimize the on-screen
presentation. In addition, a limited number of settings
associated with a specific FUNCTION can be configured
using the
FUNCTION SETUP
screen
The configurations are stored and available on a pop-up
accessed from the Projector Control screen. These are
single button FUNCTION selections.
A FUNCTION can be associated with a CPL and,
indirectly, an SPL using the SMS Controller. In this way
the same configuration is recalled whenever the associated
Content Element is presented.
MANUALLY SELECTING A FUNCTION WILL
CHANGE THE PROJECTOR SETTINGS UNTIL A
NEW FUNTION IS SELECTED.
Manual FUNCTION selection is made from a pop-up that
appears when you tap Change FUNCTION on the
PROJECTOR CONTROL screen. To access the
PROJECTOR CONTROL screen, tap
Menu
and then tap
Projector Control
. The Current FUNCTION selection is
indicated in the Function group.
FUNCTION selection may be the result of an association
between a CPL and a FUNCTION or by including a
Function in the Show Playlist.
Select Function
Projector Functions are
related to the specific
Projection Type, i.e., a 3D
FUNCTION can only be
applied when the Projection
Type is set to Single 3D. A
3D FUNCTION contains
[3D] in the Function Name.
Selection of a Projector Function incompatible with the
Projection Type will result in a warning message
appearing and the selected FUNCTION not applied. Click
OK to close the message.
To select a Function, verify the correct Projection Type is
indicated adjacent to the Lamp Indicator, tap
Menu
, tap
Projector
, tap
Projector Control
and then tap
Change
Function
. The Change Function pop-up window appears.
Tap the
UP ARROW
or
DOWN ARROW
until the
specific FUNCTION is visible and then tap the desired
FUNCTION
button. Extended Function Names may be
truncated. If there is a question as to the FUNCTION
verify the name to FUNCTION number relationship using
the SMS Controller.
The projector adjustments and settings stored as the
selected FUNCTION are immediately applied
2
to the
projector. During this period of time the auditorium screen
may go dark. No confirmation message of the FUNCTION
key selection is displayed. Also, there is no “undo”. If the
previous setup was the results of a FUNCTION setting
applied based on a CPL association, projector settings are
changed to the new settings. Adjustments made but not
saved on the FUNCTION SETUP pane will be lost.
The Projector FUNCTION selected is retained until a
different FUNCTION selection is made or until a different
FUNCTION is selected as a result of presenting a CPL
with a different FUNCTION association or a SPL that
includes FUNCTION Commands.
The FUNCTION selected will be the Current Function
appearing on the FUNCTION SETUP screen and will be
modified based on projector settings when Save to
FUNCTION is executed.
1.The SRX Controller exercises direct control over the
projector and therefore should not be used at the same time
the Projectionist Terminal or SMS Controller is in
operation.
Note
Change Function
Current Function
Note
Caution
2.Assumes that the appropriate Projection Type has been
configured.
