6-17
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Caliper
X reference pins
A
X reference
pins
A
X reference pins
A
CN102
Flat cable clamp
M4
x
8
M4
x
8
2.
Fix both consoles with the eight hexagonal head cap
bolts (M4
x
8) supplied with the extension console.
3.
Measure the dimensions
A
-
A
of the X reference pins
using a caliper. Measure the dimensions of both the
top stage and bottom stage. (Write down the measured
values in the following table.)
4.
Open the flat cable clamp of the extension console and
connect the flat cable to the connector (CN102 : SE-
590 board) of the basic console.
2-2. When connecting the extension consoles in
the range of 3 to 6
1.
Connect the extension console to the basic console.
(1) Attach the supplied pillar reference pin and spring
washer to the basic console as shown in the figure.
(2) Align the three reference pins with the reference holes
while adjusting the height of the four casters on the
extension console, and connect the extension console
to the basic console.
(3) If there is a clearance between the contact surfaces of
the basic console and the extension console, adjust the
height of another four casters to remove the clearance.
Pillar reference
pin
N20
M20
SW4
Caster
Allen wrench (10 mm)
Loosen
here.
Reference
pin
Reference
hole
Extension console
Basic console
Casters
Casters
Reference pin
Reference
hole
Table 1
Basic dimensions
Dimension of
A
-
A
(Top)
Dimension of
A
-
A
(Bottom)
Difference (Top-Bottom)
Accumulative differences (Top-Bottom)
B-EX1
EX1-EX2
EX2-EX3
EX3-EX4
EX4-EX5
EX5-EX6
40
40
40
40
40
40
6-5. Connecting Extension Consoles