6-1
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Section 6
Installation Procedure
6-1. Installation Flow
Installation of console and peripheral equipment
Removal and installation of the cabinets
(Basic console)
(Refer to Section 6-2.)
Remove the shipping metal fixtures
(Refer to Section 6-3.)
Install the basic console
(Refer to Section 6-4.)
Prevent falling
(Refer to Section 6-7.)
Set voltage selector and notes
(Refer to Section 6-8.)
Connect the cables
(Refer to Section 7.)
Install the tape drive
(Refer to Section 6-9.)
Install the PSC
Install the Package supporting equipment.
Check the operation
(Refer to Section 8.)
Connect the extension console
Connect the extension console
(Refer to Section 6-5.)
Set the switches
(Refer to Section 6-10.)
When the system is carried in to the installation location with
the same configuration as in the shipment from the factory,
this work is not necessary.
No
Yes
Yes
Connect the extension consoles in the
range of 3 to 6.
When the basic console and the extension console are going
to be installed at the same time, remove the shipping metal of
X-axis and Z-axis refering to Section 6-5.
When an extension console is going
to be connected later, attach the
shipping metal to X-axis and Z-axis
before starting to remove the X belt.
No
Install the DMSA-CBL1
Refer to Section 6-6.
Installation of the Package
supporting equipment
(Refer to Section 6-11.)
Wiring inside the console
(Refer to Section 6-12.)
No
Yes
