Sony DVS-7250, Операционное программное обеспечение

Страница: 480 / 542

14-72
Chapter 14 Setup
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
2
Press F3 (3D MOVEMENT) to change the setting.
Pressing F3 cycles through the following three settings:
×
1: Standard speed
×
2: Double speed
×
4: Quadruple speed
Selecting the fineness of image movement produced by the
MENU, SRCE or TRGT button
There are three options for the degree of fineness of control provided by
holding down the MENU, SRCE or TRGT button during a trackball or Z-ring
operation, selected by pressing F5 (FINE MODE) as follows.
/2: 1/2 of speed when the button is not held down
/4: 1/4 of speed when the button is not held down
/8: 1/8 of speed when the button is not held down
Selecting the speed of image movement produced by the VELO
HOLD button
There are three options for the maintained speed of image movement
produced by the VELO HOLD button, selected by pressing F7 (VELOCTY
HOLD) as follows.
×
1: The image continues moving at the detected speed (the speed before
you removed your hand from the trackball or Z-ring)
/2: The image continues moving at 1/2 of the detected speed.
/4: The image continues moving at 1/4 of the detected speed.
Selecting the z-coordinate-dependent trackball response
There are two options for the relation between trackball response and the
position on the z-axis, selected by pressing F9 (XY MOVE SNSTVTY) as
follows.
CNSTNT (CONSTANT): The speed of image movement in response to
the trackball does not depend on the position along the z-axis.
DPNDZ (DEPEND ON Z): The speed of image movement in response to
the trackball increases as the position recedes into the distance (i.e. as
the z-coordinate increases).
This mode provides a lighter operating touch when carrying out a
transformation in the x- and y-directions on an image positioned well
into the screen (i.e. with a large z-coordinate).