Sony DVS-7250, Операционное программное обеспечение

Страница: 449 / 542

Chapter 14 Setup
14-41
To carry out these settings, use the following procedure.
1
In the PERIPH menu, press F5 (DME IF).
The DME INTERFACE menu appears.
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
SELECT
ON AIR
TALLY
SELF
BUTTON
No. OFF
DME
SELECT
BUS
SELECT
DME
ASSIGN
RE-ENTRY
#2 #3
Function key indications in the DME INTERFACE menu
2
Press F1 (DME SELECT) or turn control knob 2 to move the cursor and
select the required DME input to which the settings apply.
3
Make the required settings in the order of (1) to (4) as shown in the table
below.
Setting Operation
(1) Making the reentry
cross-point button
setting
Hold down F3 (BUTTON No.) and press the required
cross-point button in the auxiliary bus bank. Alternatively,
hold down F3 and turn control knob 3 to select the
required cross-point button.
When not using reinput to the switcher
Press F2 (OFF), switching the REENTRY indication to
OFF.
(2) Making the
auxiliary bus
setting for output
to DMEs
Use the following procedure.
1 Press F8 (BUS SELECT) or turn control knob 3 to move
the cursor and select the required auxiliary bus output.
2 Press F6 (SELECT) to confirm the selection.
(3) Setting the on-air
tally function
Press F4 (ON AIR TALLY).
This toggles the setting between SELF and OFF.
(4) Assigning DMEs
for DME wipes
Use the following procedure.
1 Press F10 (DME ASSIGN), to display the function key
indications for DME assignment.
2 Press F2 (M/E SELECT) or turn control knob 2 to move
the cursor and select: M/E-1, M/E-2, or PGM/PST.
3 Press F6 (DME SELECT) or turn control knob 3 to
move the cursor and select the required DME.
If not using the DME wipe function, select “NO
ASSIGN”.
4 Press F4 (SELECT) to confirm the DME selection.