Sony DVS-7250, Операционное программное обеспечение

Страница: 475 / 542

Chapter 14 Setup
14-67
Linking two functions (LINK menu)
You can make the following settings in the LINK menu.
• Linking operations on two buses: You can set up one bus (the master bus)
so that operations on another bus are linked to it. You can set up a
maximum of 16 such linkages.
• Linking a specified button to a GPI output port: You can set up a button
on the switcher control panel (the master button) so that when it is
pressed a GPI signal is output from a particular GPI output port.
Linking operations on two buses
Use the following procedure.
1
In the OPERATION menu press F7 (LINK).
The LINK menu appears.
2
Press F1 (LINK).
The BUS/GPI LINK menu appears.
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
SELECT
LINK
SELECT
AUTOSEL
AUTOSEL
SETUP TYPE
MASTER
/LINK
MASTER
SELECT
#2 BUS 1 MASTER #3
Function key indications in the BUS/GPI LINK menu (when F2 is set to BUS)
3
Press F1 (LINK SELECT) or turn knob 2 to align the cursor with the link
you wish to select from the list.
4
Press F2 (TYPE) to select the type of link.
OFF: No operation.
BUS: Link two buses.
GPI: Link a button on the control panel to a GPI output port.
• When you select “BUS,” proceed to step
5
.
• If you select “GPI,” continue with the procedure in the next section,
“Linking a button to a GPI output port.”
(Continued)