20
Notes
• If you do not set the speaker correctly, the speaker may
fall down and cause injury.
• Use screws that are suitable for the wall material and
strength. In the case of a plaster board wall, attach the
screws securely to a beam and fasten them to the wall.
• Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage caused
by improper installation, insufficient wall strength,
improper screw installation, or natural calamity, etc.
Installing the speakers on a wall
(DAR-RH1000)
1
Prepare screws (not supplied) that are suitable
for the hole on the back of each speaker.
2
Fasten the screws to the wall.
The screws should protrude 8 to 9 mm.
3
Attach the supplied wall-mount pads on the
rear of the speaker.
Centre speaker
4.6 mm
10 mm
4.6 mm
10 mm
Foot pad
Surround speaker
Foot pad
4 mm
Minimum 25 mm
4.6 mm
10 mm
Speaker rear hole
8 to 9 mm
Wall-mount pads
(7 × 7 mm, 3 mm thick)
