33
d:series amplifiers
manual
control surface
dsp screen
5.5 - dsp screen
The DSP menu displays an overview of all output channel parameters when the amplifier is equipped with
the optional DSP feature.
Select the desired channel strip on the display to access edited parameters in the DSP channel menu.
NOTE: The DSP screen is only available if the amplifier is equipped with the DSP option.
1
2
3
4
Gain and delay parameter per channel
State of crossover and EQ parameters
•
Edited parameters are highlighted in green
•
Bypassed parameters are grayed out
Numbering of the corresponding output
channels
a red-colored number indicates that the
channel is muted
State of the compressor and limiter
•
comp (compressor)
A green dot indicates that the compressor
is activated, a gray dot indicates that it is
bypassed
•
gain red (gain reduction):
yellow dot indicates active gain reduction
•
lim (limiter)
A green dot indicates that the limiter is
activated, a gray dot indicates that it is off
•
gain red (gain reduction):
red dot indicates active gain reduction
1
3
4
2
Silent mode should only be activated in special situations, e.g. a very silent environment for
measurements. Do not set silent mode by default!
The cooling system of the amplifier has got an essential effect on its lifespan. To extend the
amplifiers lifespan it is recommended to do not use ‘low’ and ‘silent’ mode permanently.
Use it in sensitive situations only!
