3
d:series
amplifi
ers
manual
important service instructions
WEE recycling / disposal instructions
important service instructions
WEEE recycling / disposal instructions
CAUTION: These servicing instructions are for use by qualifi ed personnel only. To reduce the risk of
electric shock, do not perform any other servicing than that contained in the manual unless you are
qualifi ed to do so. Refer all servicing to qualifi ed service personnel.
The wheelie bin symbol found on the product or in the manual indicates that this product must not be
disposed of with other waste. It is in our category the manufacturer’s responsibility to properly dispose
of their waste electrical and electronic equipment (WEEE) at the end of its life. Due to the differences in
each EU country’s management of WEEE, please contact your local distributor or sonible directly. We
are committed to facilitate our own electronic-waste-management system, for the free of charge return
of sonible GmbH products. Arrangements are made with the dealer where you purchased the equipment
from, for the returning of all unusable equipment at no cost, to the factory in Graz, for environmental
protective disposal.
This equipment conforms to the requirements of the EMC Directive 2004/108/EC and the requirements
of the Low Voltage Directive 2006/95/EC. Standards applied: EMC Emission EN55103-1, E3
EMC Immunity EN55103-2, E3, with S/N below 1% at normal operation level. Electrical Safety EN60065, Class I
For recycling information contact sonible support at [email protected]
Security regulations as stated in the EN 60065 (VDE 0860 / IEC 65) and the CSA E65 - 94 have to be
obeyed when servicing the appliance.
Use of a mains separator transformer is mandatory during maintenance while the appliance is opened,
needs to be operated and is connected to the mains.
Switch off the power before retrofi tting any extensions, changing the mains voltage or the output voltage.
The minimum distance between parts carrying mains voltage and any accessible metal piece (metal
enclosure), respectively between the mains poles has to be 3mm and needs to be minded at all times.
The minimum distance between parts carrying mains voltage and any switches or breakers that are not
connected to the mains (secondary parts) has to be 6 mm and needs to be minded at all times.
Replacing special components that are marked in the circuit diagram using the security symbol is only
permissible when using original parts.
Altering the circuitry without prior consent or advice is not legitimate.
Any work security regulations that are applicable at the locations where the appliance is being serviced
have to be strictly obeyed. This applies also to any regulations about the work place itself.
All instructions concerning the handling of MOS-circuits have to be observed.
