16
d:series amplifiers
manual
connections, pinout and cabling
inputs and mains connection
4 - connections, pinout and cabling
4.1 - mains connection via powerCON
4.2 - inputs
The maximum current draw of the amplifier is 32A. Therefore, it is recommended to only use the original
cable shipped with the amp (country-specific power cord to powerCON 32 A with minimum cable
cross-section of 2,5mm2, H07RN or equal quality).
Depending on the ordered unit, the d:series amplifier supports one of the following mains voltages:
230VAC -5V; +20V or 115VAC -5V; +10 (50-60 Hz).
The following block diagram shows the simplified signal flow of the d:series amplifiers.
Analog Inputs (DB-25)
The DB-25 connectors located on the rear panel for analog inputs are patched in Tascam analog norm as
depicted in the following illustration.
Analog input specifications
Required level for 250W:
15 dBu
Input impedance:
95kΩ
Max. input level:
15 dBu
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
gc h gc h gc h gc h gc h gc h gc h gc h
ch 1 ch 2 ch 3 ch 4 ch 5 ch 6
ch 7 ch 8
g = ground
c = cold
h = hot
Analog In
Speaker Out
Digital In
Matrix
8
8
8
8
8
8
DSP
DAC
16/24
16/24
Input select
(groups of 8)
