SOMMER USH-9, Руководство пользователя

Страница: 26 / 132

8 Operation
8.1 Connect device to PC
1. Install the Commander support software (see Installation of Commander )
2. Connect the yellow and gray wires of the sensor cable to the RS-485 to USB converter cable
and plug it into your PC as illustrated in the figure below.
3. Connect a 9...28 VDC power supply to the USH-9.
4. Click on
Communication assistant on the right-hand side of the Commander window and follow
the instructions. During this procedure the communication assistant will search for connected
devices. Upon successful completion, the new connection is added to the connections list (tab
Connections (F8) ).
5. In the Communication Section at the right-hand side of the Commander window select Mode
Connection and the previously created connection from the drop-down list.
6. Click Connect to establish a connection with the USH-9. If the connection was successful a
green icon is displayed at the top-right corner of the Commander window.
7. Select the tab Parameters (F2) and click Download parameters from device on the left side of
the Commander window. The complete parameter list is transferred from the sensor to your
PC and displayed in the
Parameter window.
To activate the communication between your device and the Commander software follow the steps
described in
Working with connections .
8.2 How do I test the USH-9 indoors?
To test the USH-9 and to verify its distance/level measurements turn the device upside down so that
it is facing the ceiling of a room. Now, click the button
Level/distance test in the Level and distance
8
O
p
er
at
io
n
26 Manual