HGM8110DC-2 GENSET CONTROLLER USER MANUAL
HGM8110DC-2 Genset Controller 2020-02-20 Version 1.0 Page 10 of 69
4
SPECIFICATION OPERATION
Table 4 - Technical Parameters
Items
Contents
Operating Voltage
DC8.0V to DC35.0V, Continuous Power Supply.
Power Consumption
<8W (standby
≤3W)
Alternator Input Range
3Phase 4Wire
3Phase 3Wire
Single Phase 2Wire
2Phase 3Wire
AC15V-AC 360V (ph-N)
AC30V - AC620V (ph-ph)
AC15V - AC360V (ph-N)
AC15V - AC360V (ph-N)
Alternator Frequency
50 /60Hz
DC Generator Voltage Input
DC 0V-10V (Converter post voltage, ratio can be set)
Load DC Current Input
DC 4mA-20mA (Converter post current, ratio can be set)
Speed sensor voltage
1.0V to 24.0V (RMS)
Speed sensor Frequency
10,000 Hz (max.)
Start Relay Output
16 A DC28V at supply output
Fuel Relay Output
16 A DC28V at supply output
Programmable Relay Output (1)
7A DC28V supply output
Programmable Relay Output (2)
7A DC28V supply output
Programmable Relay Output (3)
7A DC28V supply output
Programmable Relay Output (4)
7A AC250V voltage free output
Programmable Relay Output (5)
8A AC250V voltage free output
Programmable Relay Output (6)
8A AC250V voltage free output
RS485 Port
Isolated, half-duplex, 9600 baud rate, longest communication
distance 1000m;
Internet Access
10Mbit
Vibration Test
5 - 8 Hz: ±7.5 mm
8 - 500 Hz: 2 g
IEC 60068-2-6
Shock Test
50g, 11ms, half-sine, complete shock test from three directions;
For each test, 18 shocks totally
IEC 60068-2-27
Bump Test
25g, 16ms, half-sine;
IEC 60255-21-2
Safety Rule Requirements
Based on EN 61010-1 mounting category (over voltage) III, 300V,