Overview of Alarms
11/2006
NCK alarms
2-230
©
Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
14320
Handwheel %1 used twice (%2) in channel %3 axis %4
Parameters:
%1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Definitions:
Informational alarm indicating that the mentioned handwheel is used twice:
The second parameter provides the explanation:
1: Block with axial handwheel override for this axis cannot be executed as the handwheel
for this axis performs a DRF movement
2: Block with velocity override of the path cannot be executed as the handwheel performs
a DRF movement for this axis of the path
3: Block with contour handwheel cannot be executed as the handwheel performs a DRF movement
for this axis of the path
4: PLC axis with axial handwheel override cannot be started immediately as the handwheel performs
a DRF movement for this axis
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating movement cannot
be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is active for
this axis with the handwheel
7: The DRF movement for this axis cannot be executed as a velocity override of the path with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as reciprocating axis
with handwheel override with this handwheel
Reaction:
Alarm display.
Remedy:
Use the handwheel for one purpose at a time only.
Program
Continuation:
Alarm display showing cause of alarm disappears. No further operator action necessary.
14400
Channel %1 block %2 tool radius compensation active at transformation
switchover
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
A change of transformation is not allowed when tool radius compensation is active.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Perform tool radius compensation in the NC part program with G40 (in a block with G00 or G01) before
performing a transformation change.
Program
Continuation:
Clear alarm with NC START or RESET key and continue the program.
