Siemens SIMATIC ET 200S, Руководство пользователя

Страница: 202 / 652

Commissioning and Diagnostics
6-42
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Analog input module error types
Table 6-14 Analog input module error types
Analog input modules Error type Meaning Remedy
2AI U
High
Speed 2AI U
Standard
2AI U High
Feature
2AI I 2WIRE
Standard
4AI I 2WIRE
ST
2AI I 2WIRE
High Speed
2AI I 4WIRE
Standard
2AI I 2/4WIRE
High Feature
2AI I 4WIRE
2AI TC
Standard
2AI TC
High
Feature 16
D
10000:
Parameter
assignment
error Module cannot use the
parameter for the
channel:
Inserted module does
not match the one
configured.
Parameter assignment
error. Correct the
configuration
(compare actual
and desired
configuration).
Correct the
parameter
assignment
(parameter
assignment of
wire break
diagnosis only
with the
permitted
measuring
ranges).
2AI I 4WIRE
High Speed
2AI RTD
Standard
2AI RTD High
Feature
9
D
01001: Error Internal module error
has occurred
(diagnostic message
on channel 0 applies
to the whole module). Replace the
module.
Feature
7
D
00111: Violation
of hi limit Value is above the
overrange. Correct the
module/actuator
match.
8
D
01000:
Violation of lo
limit Value is below the
underrange. Correct the
module/actuator
match.
------ 6
D
00110:
Open circuit
1)
Line to the sensor
interrupted. Correct the
process wiring.
------ ------ 21
D
10101:
Reference
channel error
2)
Error on the reference
channel Check the
reference
module (2AI
RTD Standard).
1) In the case of the 2AI RTD High Feature, a wire break is reported for the measuring and constant-current
lines of the sensor.
2) The following applies for the 2AI TC Standard and 2AI TC High Feature modules:
during configuration with the device database file reference channel errors are not reported if the reference
channel is incorrectly configured (not Pt100 climate range).