Siemens Healthcare Clinitek Status Connect System, Руководство оператора

Страница: 34 / 80

Clinitek Status Connect System 34 Operator’s Guide
To run a QC test, refer to section Running a QC Strip Test or Running a QC
Cassette Test above.
1. At the Results-QC Test screen, select Add QC notes .
The QC Test-Add QC notes screen displays.
2. Enter notes about this QC test.
Use the alpha keyboard to enter text.
To enter numeric text, select
123 .
3. Select Enter .
The Results-QC Test screen displays.
4. To print the results, select Print .
5. Select Done to return to the Select Ready screen.
NOTE:
You can only add QC test notes immediately after running a test.
Quality Control Errors
If the control results are outside the values stated in the package insert, try
using a new control solution. If the new solution fails again, contact the
manufacturer. For more information, refer to the quality control and urinalysis
strip or cassette package inserts.
The following table lists possible sources of error and suggested corrective
action.
Cause Corrective Action
Incorrect analyzer setup. If using a reagent strip, verify that the
reagent strip used corresponds to the
reagent strip selected.
Repeat the control procedure.
Improper technique. Carefully repeat the control procedure.
Refer to the Clinitek Status Operator’s
Manual as needed.
Deterioration of the reagent
strip/cassette test areas due to
exposure to light, ambient
moisture, or heat. Use a fresh bottle of reagent strips or
pack of cassettes to repeat the quality
control procedure.
If fresh reagent strips or cassettes fail to
give results within the expected values,
proceed to the next possible cause.
Deterioration of the control
solution. Use a fresh control solution to repeat the
quality control procedure.
If fresh solution fails to give results within
the expected values, proceed to the next
possible cause.