Shihlin electric SDE Series, Руководство пользователя

Страница: 45 / 242

37
3.8. Standard wiring method

Any person who does the wiring job should be fully competent.

Before wiring, turn off the power and wait for 10 minutes or more until the
charge LED turns off. Otherwise, an electric shock may occur.

Ground the servo drive and servo motor tightly.

Not to wire the servo amplifier and servo motor until they have been installed.
Otherwise, it may cause an electric shock.

The cable should not be damaged, stressed, loaded, or pinched. Otherwise, it
may cause an electric shock
.

The wires between the servo drive and servo motor should be correctly.
Otherwise, the servo motor may run unexpectedly.

The wirings of cables and terminals should be correct, otherwise a burst,
malfunction, etc. may occur.

Ensure that polarity (+/-) is correct. Otherwise, a burst, malfunction, etc. may
occur.

The surge absorbing diode installed to the DC relay for output control should
be proper in the specified direction. servo motor can not be connected to the
commercial power directly. Otherwise, the emergency stop and other
protective circuits may not work.

The electronic equipment around the servo drive may be interfered, please
use the EMI suppression filter to improve.

Not to connect a power factor capacitor, surge absorber or radio noise filter
with the power line of the servo motor.

When using a regenerative resistor, switch power off by AL04 signal.
Otherwise, a brake IGBT fault may cause a fire due to overheated the
regenerative resistor.

Do not modify the servo drive or servo motor.