Sharp EL-9650, Руководство по эксплуатации, Страница: 234 / 373

224
CHAPTER 10
Shows the first screen.
Create an original slide show according to the example.
<Example>
Input “Y1 = 2X–5” and “Y2 = X
2
”, and then store the equations, graph screen, table
screen, and graph and table screen in sequential order. (Set to the X-Y coordinate
system.)
1. Press
¬
. Clears the screen.
2. Press
C ®
.
Selects the original slide show (new slide show)
creation mode.
Displays the title input screen shown to the right.
3. lnput the title as “GRAPH”. (Up to 8 characters can be used for the title.)
Press
®
.
After the above steps have been completed, the preparations for the creation of the original
slide show are completed. Thereafter, you may create and store screens to complete the
original slide show. (A number from 01 is put on the screen every time it is created. The screen
will be redisplayed from 01.)
4. Press 2
-
5
®
. Inputs “2X–5” to Y1.
5. Press
®
. Inputs “X
2
” to Y2.
At this time, the screen shown to the right will appear.
First, register this screen as screen number 1.
6. Press
Ï
.
Registers the screen. (The screen shown to the right
will appear for approximately 2 seconds, showing that
the registration is completed. After the message
disappears, the screen returns to the equation screen
above.)
7. Press .
Draws graphs for “Y1 = 2X – 5” and “Y2 = X
2
”.
8. Press
Ï
.
Register the graphs. (The message, “STORE
SCREEN:02”, will appear instantaneously.)
→
EL-9650-(10)En (221-228) 8/3/00, 4:56 PM 224