SEW-Eurodrive MOVITRAC 07, Системное руководство

Страница: 83 / 170

System Manual – MOVITRAC® 07
83
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Explanation of the parameters
Parameters
87_ Fieldbus parameter settings (refer to the MOVITRAC
®
07 Communication manual for more information)
P870 ... P872 can be used for defining the contents of process output data words PO1 ... PO3. This definition is neces-
sary so MOVITRAC
®
07 can allocate the appropriate setpoints.
The following process output assignments are available:
NO FUNCTION:
The content of the process output data word is ignored.
SPEED: Speed setpoint selection in rpm.
MAX. SPEED: Maximum speed (P302).
RAMP: Ramp time for setpoint selection (P130 / P131).
CTRL. WORD 1: Control signals for start/stop, etc.
SPEED [%]: Selection of a speed setpoint in % of 3000 rpm.
PI CTRL [%]: PI controller setpoint
870 Setpoint description PO1 Factory setting: CTRL. WORD 1
871 Setpoint description PO2 Factory setting: SPEED
872 Setpoint description PO3 Factory setting: NO FUNCTION
P873 ... P875 can be used for defining the contents of process input data words PI1 ... PI3. This definition is necessary
so MOVITRAC
®
07 can allocate the appropriate actual values.
The following process input assignments are available:
NO FUNCTION:
The content of the process input data word is 0000
hex
SPEED: Current actual speed in rpm.
ACTIVE CURR.: Momentary active current of the inverter in % of I
N
.
OUTP.CURRENT: Momentary output current of the inverter in % of I
N
.
STATUS WORD1: Status information of the inverter.
SPEED [%]: Momentary actual speed value in % of 3000 rpm.
IPOS PI-DATA: IPOS process input data.
PI CTRL [%]: Actual values of the PI-controller.
873 Actual value description PI2 Factory setting: STATUS WORD1
874 Actual value description PI2 Factory setting: SPEED
875 Actual value description PI3 Factory setting: OUTPUT CURRENT
876 PO data enable OFF
The process output data which were most recently valid remain in effect.
ON
The process output data sent most recently by the fieldbus controller
come into effect.
9__ IPOS/LOGODRIVE parameters
93_ IPOS/LOGODRIVE special functions
Parameters P931 and P932 are only relevant for LOGODrive units.
931
•
Task 1/2 on / ON
Task 1 and task 2 are running.
off / OFF
Task 1 and task 2 are stopped.
932 Task 2 (display only) on / ON
Task 2 is running.
off / OFF
Task 2 is stopped.
No. OP Name Description
P6..
P60.
P600