SEW-Eurodrive MOVITRAC 07, Системное руководство

Страница: 145 / 170

System Manual – MOVITRAC® 07
145
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Manual speed control module and external setpoint selection
Startup
Enable direction of
rotation with RS-
485 or SBus The direction of rotation is determined by the setpoint if you set P101 Control signal
source and P100 Setpoint source to RS485 or SBus (RS485 only for service purposes).
You must enable the setpoint via SBus or RS-485 using the "CW/STOP" or
"CCW/STOP" terminal. SEW-EURODRIVE recommends giving the enable using the
"CW/STOP" terminal which has a fixed program setting, rather than with the program-
mable "CCW/STOP" terminal.
The "CW/STOP" and "CCW/STOP" terminals determine the direction of rotation if:
• P101 Control signal source is set to RS485 or SBus
and
• P100 Setpoint source is set to
– UNIPOL/FIX.SETPT
– MOTOR POT
– FIX SETP+AI1
– FIX SETP*AI1
– FREQUENCY INPUT
STOP/RESET key
The STOP/RESET button has priority over a terminal enable or an enable via the inter-
face. If you stop a drive using the STOP/RESET key, then you must re-enable it using
the RUN key.
The STOP/RESET key can be used for performing a reset after a fault has occurred with
a programmed fault response. The drive is then inhibited and must be enabled using the
RUN key.
RUN key If you stop the drive with the STOP/RESET key, the
Stop
display flashes. This indicates
you have to enable the drive using the "RUN" key.
"CW/STOP"
terminal "CCW/STOP"
terminal Direction of rotation enable
0 0 Drive inhibited
1 0 CCW and CW (direction of rotation is dependent on the
setpoint)
0 1 CCW and CW (direction of rotation is dependent on the
setpoint)
1 1 Drive inhibited
STOP
RESET
Switching the supply system off and on re-enables the inverter!
RUN
0 0
I