SEW-Eurodrive MOVITRAC 07, Системное руководство

Страница: 79 / 170

System Manual – MOVITRAC® 07
79
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Explanation of the parameters
Parameters
73_ Brake function
736
•
Brake application time
The start and stop speeds
are fixed:
•
n
start
= 15 rpm
• n
stop
= 60 rpm
The start and stop speeds
are not in effect when the
setpoint speed is slower.
Setting range 0 ... 0.1 ... 2 [s]
The parameter applies both to the brake release time and the brake reaction
time.
[1] = Enable
[2] = /Brake
[3] = Out stage on
[4] = Rot. field on
t
M
= Premagneti
zation time
t
B
= Braking time
n1 = Start speed
n2 = Stop speed
n3 = Setp. speed
76_ Manual operation
760
•
Locking RUN/STOP keys
(see Startup / External set-
point selection) no / NO (RUN/STOP keys are activated and can be used for starting and
stopping the motor)
yes / YES (RUN/STOP keys are locked and therefore do not function)
8__ Unit functions
80_ Setup
P802 can be used to reset the factory settings for almost all parameters; these are stored in the EPROM. In addition,
you can also reset the unit to its delivery condition. The factory setting function does not affect the following:
•
P30_ (Limits)
• P321 ... P324 (Motor adjustment)
• P700 (Operating mode)
• P810, P811, P813, P814, 816 (Serial communication)
• P840 (Manual reset)
Selecting DELIVERY STATE also resets the parameters listed above.
The statistical data must be reset separately using
P804 Reset statistic data. Setting the parameter to YES performs the
factory setting function. During this time, the display shows
SEt
. The inverter displays its previous operating status once
again after the factory setting function has finished. P802 automatically reverts to NO.
Activating the factory setting function overwrites almost all parameter values. Store the set values using MOVITOOLS
®
before you activate the factory setting. Once the factory setting function has been used, you can adapt the parameter
values and terminal assignments in accordance with the requirements.
No. OP Name Description
P6..
P60.
P600