Seakeeper 7000A GYRO, Руководство по установке

Страница: 34 / 58

WORK INSTRUCTIONS Page 2 of 4 Product: M7000A Document #: 019
Process: Installation Instructions, 4-Pin Shielded EMC Connector Rev.: 2
Step 3 - 7
3. Trim cable jacket as shown in cable
preparation detail.
4. Fold braided shield back over cable to
expose inner conductors.
Notes: Maintain the weave of braided shield.
Remove all shield clippings from cable and
connector.
5. Strip insulation on wires as shown.
6. Install ferrules on wire ends using
Weidmüller crimp tool PZ 4 (or equivalent).
Note: Ferrules are not required if bare conductor
nearly fills the screw terminal.
Ferrule part numbers: McMaster-Carr 7950K76,
Weidmüller 9025740000.
7. Insert wire ferrules into connector screw
clamps according to picture below and
tighten. Apply dielectric compound to
terminals to prevent corrosion.
(Alarm) 1
2 (Alarm)
3 (Raw Water Pump Control)
(Raw Water Pump Control) 4
Pins numbered on connector