Seakeeper 7000A GYRO, Руководство по установке

Страница: 3 / 58

INSTALLATION
MANUAL
Product: Document #: Rev: Page:
MODEL 7000A GYRO 90051 3 1 of 10
Section 1: MECHANICAL INSTALLATION
1.0 Introduction
This document is intended to give details and guidance to a boat builder or equipment installer to install
the Seakeeper, Inc. Model 7000A Stabilizing Gyro. The gyro is capable of producing loads up to 23.5 kN
(5300 lbs.) on each foundation saddle and careful consideration should be given to foundation design to
insure it is capable of transferring these loads into the hull. It is assumed that personnel involved in
installation are familiar with GRP structures as well as the use of high strength adhesives that will be
used to bond the gyro to the hull structure. It will be helpful to the installer to have reviewed the
following list of reference drawings to ensure the installation procedure is fully understood.
Reference Drawings
90030 Model 7000A Gyro Hardware Scope of Supply
90031 Model 7000A Gyro Installation Details
90003 Model 7000 Gyro Cooling Schematic
90032 Model 7000A Gyro Assembly & Parts List
90023 Model 7000A Gyro Cable Block Diagram
90012 Model 7000 Gyro Installation Jig Assembly
FIGURE 1 – MODEL 7000A GYRO