Sea Recovery SRC Ultra Whisper Compact 200, Руководство пользователя

Страница: 95 / 299

Sea Recovery Ultra Whisper Rev. A
1. Attach the supplied Feed Water Connector Assembly [3], 1/2 “ FNPT elbow with attached
1/2” hose barb, to the boats Sea Cock 1/4 turn ball Valve [2]. Position the Outlet Hose Barb
towards the Sea Strainer Inlet [4].
2. Attach the supplied Brine Discharge Tee Connector [22] Assembly, 1/2 “ FNPT elbow with
attached 1/4” Tube Fitting, to the boats Over board Discharge Fitting [23]. Position the
Inlet Tube Fitting towards the System Brine Discharge.
3. Attach the supplied Potable Water Storage Tank Tube Connector [31] 1/4” MNPT x 1/4” Tube
Fitting to the 1/4” FNPT tap at the Potable Water Tank [32]. The Product Water line may also
be attached to the Potable Water Storage Tank Fill Line rather than drilling and tapping into the
top of the tank itself.
CAUTION: Do not use water tank diversion valves in this line to fill more than one tank. If it is absolutely
necessary to use a diversion valve to fill more than one tank use only a “never closed” type ball valve which
allows water to flow regardless of the valve handle position. If a valve in this line is closed during operation
extensive damage to the system will occur. Damage caused to the system due to installation of valves in the
product water line is the responsibility and liability of the installer and is not covered by the Sea Recovery
warranty.
4. The Sea Strainer [4] is mounted in an accessible location below water level between the Inlet
Sea Cock Valve [2] and Feed Pump [6]. Allow at least 4 inches (10 cm) of clearance below
the bowl to access the mesh screen for cleaning or replacement.
5. The ***Inlet Rinse Clean Valve [36] is mounted in an accessible location below water
level between the Sea Strainer [4] Outlet and the ***Fresh Water Flush Check Valve
[35] Inlet if used, otherwise the Feed Pump [6] Inlet.
6. The Feed Pump [6] is mounted at or below water level to assist the pump in priming.
Mount the Feed Pump between the Sea Strainer [4] Outlet and the ***Plankton
Filter [7] Inlet if used, otherwise the Prefilter [13] Inlet.
It is best to mount the Feed Pump below water level to assist priming, and in an
accessible location to allow access for maintenance.
CAUTION: Do not mount the pump head vertically above the motor else motor damage will occur if the pump
or it’s fittings should develop a leak. Eventually, from use the pump seal will wear and leak requiring
replacement. Water damage to the motor, if mounted improperly, is the responsibility and liability of the
installer and not covered by Sea Recovery warranty.
CAUTION: Mounting of the Feed Pump above water level will cause a vacuum at the inlet of the pump and
will result in premature wear resulting from cavitation. Improper installation of the Feed Pump causing
excessive vacuum at the inlet of the pump resulting in cavitation and premature wear is the responsibility and
liability of the installer and not covered by the Sea Recovery warranty.
Section 2 Page 56 of 68