Sea Recovery SRC Ultra Whisper Compact 200, Руководство пользователя

Страница: 228 / 299

Sea Recovery Ultra Whisper Rev. A
A. ELECTRICAL CONNECTIONS
CAUTION: ELECTRICAL SHOCK HAZARD . A Volt / Ohm Meter will be necessary. The following procedures
expose the technician to High Voltage and electrical shock hazard. Only attempt this if you are a qualified
electrician and only if surrounding conditions are safe.
CAUTION: Always allow slack in electrical cables. Allow the cable to enter or leave from the strain relief in a
straight manner for several inches to ensure proper connection, to relieve stress to the cable and fitting, and to allow
ease of detachment and reattachment for maintenance or replacement. If electrical cables are pulled tight causing
them to bend at the strain relief they will pull out of the strain relief causing a dangerous electrical shock condition,
the wire may break, and the strain relief will loose its water tight integrity.
CAUTION: Review the “Check Off Q.C. Sheet” that accompanied this Owners Manual and the Invoice that
accompanied this Ultra Whisper System to ensure that it has been configured from Sea Recovery for the
appropriate and proper DC Voltage or AC Voltage, Cycles, and Phase.
¾ A 12 VDC System will NOT function from 24 VDC Power.
¾
A 24 VDC System will NOT function from 12 VDC Power.
¾ An AC 50 Hz System will operate at higher than normal pressure and will over heat the Feed Pump Motor if
connected to a 60 Hz power source.
¾ An AC 60 Hz System will operate at lower than normal pressure, will produce 17% less product water than
specified, and the product water will be high in salt content if connected to a 50 Hz power source.
1. Remove the Front cover from the system controller to access the Main Terminal Strip and Printed Circuit
Board.
REFER TO APPROPRIATE WIRING DIAGRAM IN THIS SECTION
REFER TO APPROPRIATE WIRING SIZE LISTED IN THIS SECTION
REFER TO APPROPRIATE CIRCUIT BREAKER SIZE LISTED IN THIS SECTION
NOTE: System Configuration, Optional Accessories present, and the specific model all are contributing factors
to the amount of electrical connections required during installation. The following items are listed but may
either not be present (Optional Accessory not ordered) or may already be connected. Track each electrical wire
to ensure proper connection. (*** = Optional Accessory)
2. Ultra Whisper System Required Electrical Connections:
Feed Pump Electric Motor [6]
Low Pressure Switch [10]
High Pressure Switch [11]
Fresh Water Flush Pump Electric Motor [33]
3-way Product Water Diversion Solenoid Valve [26]
*** U.V. Sterilizer [30]
*** Remote Controller [40]
*** Soft Start [41]
Electrical Power to the System
section 8 page 3 of 12