Sea Recovery SRC Ultra Whisper Compact 200, Руководство пользователя

Страница: 97 / 299

Sea Recovery Ultra Whisper Rev. A
13. The Energy Transfer Device [17] is mounted to a flat surface between the 5
micron Prefilter [14] outlet and the R.O. Membrane Vessel [20] inlet.
Attachment of the Energy Transfer Device to the R.O. Membrane Vessel is done
using the two supplied 6 foot (1.82 meter) long High Pressure Hoses [19 & 21].
Ensure that the two high pressure hoses will easily connect between the Energy
Transfer Device [17] and the R.O. Membrane Vessel [20]. Longer, or shorter,
High Pressure Hoses may be ordered from Sea Recovery.
PORT "S"
BRINE DISCHARGE OUTLET
TO CLEAN/RINSE VALVE [34]
OR BRINE DISCHARGE TEE COLLECTOR [20]
"P"
"R"
"E" "S"
ETD [17] REAR VIEW
PORT "P"
PRESSURE OUTLET
TO R.O. MEMBRANE VESSEL INLET
CONNECTION WITH HIGH PRESSURE HOSE
PORT "E"
FEED WATER INLET
FROM 25 MICRON PREFILTER OUTLET
CONNECTION WITH CLEAR BRAIDED HOSE
PORT "R"
PRESSURE RETURN
FROM R.O. MEMBRANE VESSEL OUTLET
CONNECTION WITH HIGH PRESSURE HOSE
12. The Reverse Osmosis Membrane and Pressure Vessel
Assembly [20] is mounted horizontally to any surface. If
the assembly is mounted vertically ensure that the inlet is
at the bottom and the outlet is at the top. This ensures
that any air present in the vessel will be displaced during
operation. Attachment of the R.O. Membrane Vessel [20]
to the Energy Transfer Device [17] is done using the two
supplied 6 foot long High Pressure Hoses [19 & 21].
Ensure that the two high pressure hoses will easily
connect between the Energy Transfer Device [17] and the
R.O. Membrane Vessel [20].
FROM PORT "P"
OF ETD [17]
PRESSURIZED
FEED WATER
INLET
PRODUCT WATER OUTLET
TO PRODUCT
WATER MANIFOLD
BRINE
DISCHARGE OUTLET
TO PORT "R" OF ETD [17]
FLOW DIRECTION
13. The System Control Panel is mounted to a flat vertical
surface in a location that allows ease of access to operate the
system. Water flows through the control panel. Do not
mount the Control Panel above any electrical or electronic
component.
14. The Charcoal Filter [28] is mounted in an accessible location to a vertical bulkhead. Allow
minimum 4 inches (10 cm) below the bowl for filter element removal.
CAUTION: Product water may spill during filter element replacing. Therefore, Do Not
mount the charcoal filter above any electrical or electronic component
Section 2 Page 58 of 68