8
3. Statim Data Logger Quick Setup Guide
For units with Rev. 7 Printed Circuit Board Only
Note: Please do not connect Statim Data Logger. Follow instruction below
first.
Step 1: Selection of the USB Flash/MSD Option.
a) Selection of the USB Flash/MSD Option
i.
Power up unit while holding the Stop button pressed. The
user menu is going to be displayed.
ii.
By using Unwrapped and Wrapped keys scroll down to
RS232. Press Rubber and Plastic key.
iii.
The RS232 configuration menu is displayed. By using
Unwrapped and Wrapped keys scroll down to the
USB/Flash MSD option. Press Rubber and Plastic Key.
b) Selection of the Serial port Bitrate to 9600
i.
By using Unwrapped and Wrapped keys scroll down to
Serial Port Bitrate.
ii.
The Serial Port Bitrate is going to be displayed. By using
Unwrapped and Wrapped keys scroll down to 9600. Press
Rubber and Plastic Key.
c) Selection of Printer user ° Char
i.
By using Unwrapped and Wrapped keys scroll down to
Printer user ° Char.
ii.
Use Unwrapped Key to increment value by one, Wrapped
Key to increment value by ten. Select value 32 [0x20]. Press
Rubber and Plastic Key.
d) Save and Exit
i.
By using Unwrapped and Wrapped keys scroll down to Save
and Exit. Select by pressing Rubber and Plastic key.
ii.
The following screen is going to be displayed:
HH:MM DD/MM/YYYY
“MSD NOT DETECTED”/”INSERT FLASH/MSD”/”SELECT A CYCLE”
Step 2: Setup Date / Time.
a) Power up unit while holding the Stop button pressed. The user
menu is going to be displayed.
b) By using Unwrapped and Wrapped keys scroll down to Time/Date
Setup. Press Rubber and Plastic key.
c) Setup Time and Date by pressing Unwrapped, Wrapped, and
Rubber and Plastic Keys. Press stop when done.
HH:MM DD/MM/YYYY
“MSD NOT DETECTED”/”INSERT FLASH/MSD”/”SELECT A CYCLE”