
INTEGRA/-S/-G/-GS User Manual WEB GUI
SAF Tehnika JSC
74
Modify mode
1)
CoSQ
–
Indicates whether CoSQ (Class of Service Queue) is enabled on the egress
direction of a particular port (status mode); allows enabling or disabling CoSQ on
available ports (modify mode). CoSQ is enabled by default on the WAN port.
2)
Port based priority
–
Indicates whether port-based prioritization is enabled (status
mode); allows enabling or disabling port-based prioritization on available ports
(modify mode). If enabled all packets on the egress of a port are put in a specified
queue. 802.1p (PCP) and DiffServ (DSCP) values are ignored. Available values are
0…7 according to eight available priority queues from the lowest to the highest.
3)
802.1p
–
Indicates whether the 802.1p mapping is enabled (status mode); allows
enabling or disabling 802.1p mapping on available ports (modify mode). If enabled
configured mapping (
) is taken into account.
4)
DiffServ
–
Indicates whether DiffServ prioritization is enabled (status mode); allows
enabling or disabling DiffServ prioritization on available ports (modify mode). If
enabled DSCP value is taken into account according to configured mapping
(
5)
Schedulers mode
–
Indicates whether frame-based (SP/RR/WRR
–
Strict
Priority/Round Robin/Weighted Round Robin) or byte-based scheduling schemes
(SP/DWRR
–
Strict Priority/Deficit Weighted Round Robin) are available (status
mode); allows switching between frame-based to byte-based scheduling schemes
(modify mode). A specific scheduling scheme can be set in
. The s
cheduler’s
mode specifies how frames are handled at egress
flow. DWRR compared to WRR is configured in kilobytes (KB), rather than the number
of frames passed. The default setting is the frame-based mode.
6)
By pressing
„Execute configuration”
,
changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS. If
„Rollback on”
is
selected, the configuration will be reverted in case erroneous configuration changes
are applied.
CLI commands (
Chapter 4: COMMAND LINE INTERFACE
network qos set
<port>
cosq
state
{enable|disable}
Use to enable or disable CoSQ priority queues on a
particular port.
network qos set
<port>
vlan
state
{enable|disable}
Use to enable or disable ingress 802.1p mapping on a
particular port.
network qos set
<port>
diffserv
state
{enable|disable}
Use to enable or disable ingress DiffServ mapping (DSCP)
on a particular port.
network qos reset config
{LAN1|LAN2|LAN3|WAN|all}
Use to reset QoS configuration on a particular port or all
ports simultaneously.
Содержание Integra
