SAF Integra, Руководство пользователя, Страница: 25 / 94

INTEGRA/-S/-G/-GS User Manual INSTALLATION
SAF Tehnika JSC
25
Integra-GS 15-42GHz* remote mount kit assembly
Tools required : Size 5 Allen wrench
13mm (0.512”) wrench (not supplied)
1
Assemble Mounting Bracket using a 13mm
wrench:
Screw one hex flange nut [4] on each of the
four threaded rods [3]. Insert threaded rods into
available holes of the mounting clamp [1]. Put
hex nuts [4] on the other side of the clamp and
screw on the threaded rods until these are
visible from another side of the clamp, not
more than 2mm. Tighten hex flange nuts with
torsion 20...25 N·m.
Attach two mounting bracket clamps [2] on
threaded rods [3] as shown in the picture and
afterward screw on the remaining four hex
flange nuts [4] on all threaded rods.
2
Attach the waveguide transition flange to the
mounting bracket using a size 5 Allen wrench:
Put the flat side of the transition flange [5] on the flat
side of the mounting clamp [1] as shown in the picture
and screw in four socket head screws [6] from another
side of the clamp. Two screws [7] have to be screwed
into the antenna flange of ODU (not shown here).
Screws' heads serve as guiding pins while the ODU is
attached to the transition flange [5].
3
View of the assembled mounting bracket on
the thick pole mast:
Bracket clamps in the following position
support mast diameters of 55..120 mm.
4
View of the assembled mounting bracket on the thin
pole mast:
Bracket clamps in a reverse position support smaller
mast diameters of 25...75mm.
*Integra-GS 15/18/17/23/24/26/32/38/42GHz are separate FODU models