SAF Integra, Руководство пользователя, Страница: 36 / 94

INTEGRA/-S/-G/-GS User Manual WEB GUI
SAF Tehnika JSC
36
Parameters on Main page
1) License remaining time – shows the amount of time remaining for an active time-
limited license; in case of an unlimited time license, “Unlimited” is being shown.
When the license expires, the modulation will drop to “4QAM FEC Limited” , the link
capacity will drop to 256Kbps and you will see a warning.
2) Radio side – shows the radio side of the local and remote Integra-G.
3) Tx mute – Tx shows if the transmitter is currently muted (“Enabled”) or active
(“Disabled”).
4) Tx power – shows current transmitter power in dBm. will appear if the value is
dynamically changed according to the current ACM modulation. Move the mouse
over for an explanation.
5) ATPC – shows if ATPC is enabled or disabled.
6) Duplex shift – shows the margin between the transmitting and receiving frequencies.
7) Tx frequency – shows the transmitting frequency.
8) Rx frequency – shows the receiving frequency.
9) Rx level – shows the current level of the received signal. It must not differ
significantly from the previously calculated value.
10) Bandwidth – shows the width of currently utilized bandwidth in MHz.
11) Modem profile – Indicates currently configured modulation.
The “FEC” suffix indicates a better sensitivity mode (longer FEC overhead), while
“WeakFEC” indicates a higher capacity mode (shorter FEC overhead).
“WeakFEC” is available only for the highest modulation in the selected channel
bandwidth.
An option with “ACM” (please refer to the chapter Integra-G block diagram
The general internal block diagram of Integra-G is shown below. It has a built-in
Gigabit Ethernet Network Processor that has three LAN ports: LAN1 - 1Gbps PoE-in