Sabo 31-V EL, Руководство оператора

Страница: 35 / 72

9
18 TROUBLESHOOTING
Fault Possible cause Remedy
Motor does not start up
within 5 seconds of the
device being switched
on
No mains voltage. Connect the mains plug C2 .
Check the fuse.
Connection cable
damaged. Have it checked by an
authorised workshop.
Cutter blade shaft
blocked Have scarifying depth
checked.
Clean the cutter blade shaft
(remove the mains plug first!)
Tilt the machine during start-
up.
Have it checked by an
authorised workshop.
Motor stops
Grass is too high Mow the lawn first.
Blockage by foreign
bodies Have machine checked by an
authorized specialist
workshop.
Working depth to deep Re-adjust the working depth
V2 .
Unsatisfactory result
Grass is too high Mow the lawn first.
Blades are worn
Adjust the working depth
V2 .
Have the blade shaft
replaced by an authorized
specialist workshop
Working depth not
suitable for grass and
ground conditions Re-adjust the working depth
V2 .
Extreme vibration
Have it checked by an
authorized dealer
Blade shaft will not
turn
Drive belt defective
Have it checked and replaced
if necessary by an authorized
specialist workshop.
Repairs to electrical machines must always be performed only by qualified electricians.
Please do not repair them yourself.
In the case of faults and defects which have not been listed here, please contact the
nearest authorized dealer. This applies in particular to appliances with electrical motors,
as when these are repaired they must always undergo an insulation protection test.
Your authorized dealer will also help you if you do not wish to perform any of the
maintenance work described here yourself.
19 TECHNICAL DATA
Motor
Motor Alternating current motor
Connection voltage 230 V
Power 1400 W (31-V EL)
1600 W (35-V EL)
Motor speed 3000 min
-1
Scarifier
Housing Impact-resistant plastic (ABS)
Operating width 310 mm (31-V EL)
350 mm (35-V EL)
Scarifier cutters 13 pieces (31-V EL)
15 pieces (35-V EL)
Adjustable-height handlebar 2-way
Grass collector capacity 50 litres
Weight
18.5 kg (31-V EL)
20 kg (35-V EL)
Length 1330 mm
Width 490 mm
Height 990 mm
Wheels front / rear Ø 180 mm / Ø 180 mm
Bearing front / rear Sleeve bearing
Sound power level
Guaranteed sound power level;
measured according to 2000/14/EC L
wa
= 87 dB(A)
Sound pressure level
Emission sound pressure level at operator's workplace;
measured according to DIN EN 13684
Measuring inaccuracy; according to ISO 4871 L
pA
= 78 dB(A)
1.5 dB
Vibrations
Vibrations on the handlebar;
measured according to DIN EN 13684
Measuring inaccuracy; according EN 12096 a
hW
= 1.5 m/s
2
0.8 m/s
2
20 ORIGINAL SPARE PARTS
Scarifying blades For safety reasons, scarifying blades
must always be replaced by an
authorised workshop.
This workshop has the respective spare
part numbers for the scarifying blades
available.