Roland VersaStudio BT-12, Руководство по эксплуатации

Страница: 60 / 234

58
2. Preparing for Printing
Loading Fabrics
This section explains the procedures for loading fabrics.
Loading a Fabric in the Standard Tray
This section explains how to load a fabric in the A4 standard tray. The same operation applies
when the A5 tray is used.
• When printing on thin fabrics, the ink may adhere to the table. Place paper or something
similar on the table before loading the fabric.
1.
Press the [Power] key.
Remove the tray after turning the power on. If the tray is mistakenly removed before turning
the power on, turn the power off once, and then turn the power on again.
2.
Check that the tray stand comes to the front.
If the tray stand does not come to the front, press the [Tray] key and move the tray to the
front.
3.
Lift the tray slightly, pull it to the front to remove it.
4.
Press the unlock button and lift the cover.
DSA348
5.
Put marks on the fabric for when loading it in the tray.
The image will be printed in the direction from the front side to the back side of the tray.
Turn the protection cover inside out and put it on the fabric in the direction as shown in the
figure, and then use a pen with erasable ink to make the marks through the holes in the
protective cover.
• When loading or removing fabrics, keep your hands or fingers clear of the tray.
Otherwise, your hands or fingers might get caught, resulting in injury.