Roland VersaStudio BT-12, Руководство по эксплуатации

Страница: 193 / 234

191
The Tray Does Not Operate Correctly
6.
Check that "Press # to start" is displayed, and then press the [#Enter] key.
Auto adjustment starts after the tray is loaded into the machine. After auto adjustment is
completed, the tray returns and stops in position so that you can see the tray positioning line
on the left side of it.
• The value set by adjustment is stored in [Manual Adjust] in the [Maintenance] menu.
• If an error occurs during auto adjustment, perform the operation from Step 1 again.
Adjusting the height of the tray manually
• If you enter a negative value as the height value, the height position sensor in the machine
may react. Load the fabric correctly so that the printing surface can be flat.
• If the fabric is not correctly set after the height of the tray is adjusted manually, the
machine might not start printing because a height position sensor in the machine reacts
when you send a print job. In this case, remove the tray, load the fabric into the tray
correctly, and then load the tray into the machine.
• The image quality might deteriorate if you change the height value significantly. In this
case, adjust the registration.
• Adjust the height little by little so that the print side is not rubbed.
When printing starts, the machine adjusts the height of the tray according to the height value
specified in the [Maintenance] menu. If the printed image is blurry or there is dust stuck to it, or
the height of the tray may not be adjusted appropriately, adjust the height of the tray manually
using the [Maintenance] menu.
If the distance between the print head and the fabric is too large, the printed image might be
blurry. If this is the case, enter a negative value as the height value.
DSA214
If the distance between the print head and the fabric is too small, dust might stick to the fabric. If
this is the case, clean both the Maintenance Unit and print head. If the problem is not resolved,
enter a positive value as the height value.