Roland V-Drums TD-8, Руководство пользователя

Страница: 134 / 224

134
Chapter 7 Making Global Settings for the TD-8
Using the TD-8 with Acoustic
Drums (Acoustic Drum Trigger)
If you have the trigger type set for an acoustic drum trigger,
and the sound is not being produced correctly, use the
advanced mode settings.
First, referring to “How to Use the Acoustic Drum Trigger” (p.
173), install the acoustic drum trigger. When you have finished
with the installation, proceed with the following settings.
Specifying a Trigger Type
fig.08-018
1.
1. Press [SETUP], then [F1 (TRIG)].
[SETUP] lights, and the “TRIGGER” screen appears.
2.
Press CURSOR [ ] to move the cursor to bank number.
3.
Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select the bank number.
4.
Press CURSOR [ ] to move the cursor to trigger type.
5.
Strike a pad.
The cursor moves to the setting for the pad that was struck.
You can make the selection by pressing CURSOR [ ]
or [ ] and [TRIG SELECT].
6.
Press [INC/+] or [DEC/-] or rotate the VALUE dial to
make the setting.
Refer to the following chart, and specify the
corresponding pad type.
Setting the Trigger Parameters
If you are using acoustic drum triggers, make settings
following the sequence given below to ensure the best results.
For more detailed information about each parameter, refer to p.
129–p. 133.
1.
Refer to the explanation in the foregoing paragraph and
select the Trigger Type.
2.
Set the “THRESHOLD” and “CURVE” parameters to
“normal” values.
Press [SETUP], then [F1 (TRIG)], and then [F1 (BASIC)]
to access the “TRIGGER BASIC” screen. Use CURSOR
[
] or [ ] to move the cursor to the parameters, and
use [INC/+] or [DEC/-] or rotate the VALUE dial to
make the following setting.
THRESHOLD: 0
CURVE: LINEAR
3.
Set the “SENSITIVITY.”
In the setting page of step
2
, use CURSOR [ ] or to
move the cursor to the “SENSITIVITY.” Make settings so
that the input indicator in the right part of the display
reaches the maximum level when the pad is struck
strongly.
4.
Press [F1 (ADVNCD)].
The “TRIGGER ADVANCED” screen appears.
5.
Set the “SCAN TIME.”
Strike the head several times with the same force, and
adjust this parameter if the volume is uneven.
6.
Set the “RETRIGCANCL.”
This prevents multiple notes from sounding when a
drum is struck once (mainly for a snare drum or toms).
7.
Set the “MASK TIME.”
On a kick pad, this prevents two sounds instead of the
intended “one”
8.
Set the “CROSSTALK.”
This prevents other instruments with drum triggers from
sounding when a drum to which a drum trigger has
been attached is struck. While this becomes more
effective as the value is increased, keep the value as low
as practicable.
9.
Press [SETUP], then [F1 (TRIG)], and then [F1 (BASIC)]
to display the “TRIGGER BASIC” screen.
10.
Set the “THRESHOLD.”
If notes are unintentionally sounded even after you have
adjusted the “CROSSTALK” setting, adjust the
“THRESHOLD.” If this parameter is raised excessively,
playing softly may NOT trigger the TD-8, so keep the
value as low as possible.
11.
Set the “CURVE.”
If changes in playing dynamics do not produce a natural
change in the volume of the TD-8 instrument, adjust this
parameter.
Display Model used
KIK kick drum
SNR snare drum
TOM tom tom
FLR floor tom