Roland Juno-Stage, Руководство пользователя

Страница: 85 / 256

85
Chapter 5. Applying Effects to the Sound
A patch or rhythm set contains parameters that specify whether pitch bend, controller number 11 (expression), and controller number 64 (hold
1) will be received for each tone or rhythm tone (p. 112, p. 124). If these settings are “ON,” receiving that MIDI message will not only change
the setting of the assigned destination parameter, but will also apply the corresponding pitch bend, expression, or hold 1 effect. Leave them
“OFF” if you only want to control the multi-effect parameter.
A performance contains parameters that specify whether specific MIDI messages will be received for each MIDI channel (p. 138). If you want to
use multi-effect control, make sure that reception is enabled for the corresponding MIDI message. If MIDI messages cannot be received, multi-
effect control will not work.
Parameter Range Explanation
Source (1–4)
(Control Source)
OFF,
CC01–31,
CC33–95,
PITCH BEND,
AFTERTOUCH,
SYS CTRL 1–4
Specifies the MIDI message that will control the corresponding MFX control parameter.
OFF: MFX will not be used.
CC01–31: Controller number 1–31
CC33–95: Controller number 33–95
PITCH BEND: Pitch bend
AFTERTOUCH: Aftertouch
SYS CTRL 1–4: Use the controller that is assigned by the System setting Sys Ctrl 1–4 Source
(p. 148).
Destination (1–4)
(Control Destination)
Refer to “Multi-Effects
Parameters (MFX1–3,
MFX)” (p. 163)
Selects the multi-effect parameter that will be controlled by control source 1–4.
The type of parameters that can be selected will depend on the type of multi-effect you’ve se-
lected in MFX Type.
Sens (1–4)
(Control Sensitivity)
-63–+63
Specifies the depth of multi-effect control.
Specify a positive (+) value if you want to change the value of the assigned destination in a
positive direction (larger, toward the right, faster, etc.), or specify a negative value (-) if you
want to change the value in a negative direction (smaller, toward the left, slower, etc.).
Larger values will allow a greater amount of control.
MFX Control Channel 1–16, OFF
Specify the reception channel that will be used when using MFX control to control the multi-
effect parameter in real time, when MFX 1–3 Source (p. 82) is set to “PRF.”
Leave this “OFF” if you’re not using MFX control.
* This parameter is not available in Patch mode.
JUNO-STAGE_e.book 85 ページ ２００８年１０月１７日 金曜日 午後１２時２７分