Rockford Systems, LLC.
Call: 1-800-922-7533
13
SSC-1500 Part Revolution Solid-State Control
SECTION 3—INSTALLATION OF COMPONENTS
Introduction
The following additional materials are required to install the equipment in this shipment.
1.
Wire: Size and type will depend on local ordinances or plant practices. We recommend stranded machine tool wire with appropriate color coding.
Never use solid wire
—the vibration caused by these machines precludes the successful use of solid wire for these installations.
2.
Numbered wire markers: Made of suitable material to resist oil, grease, etc., and remain firmly attached to the wire.
3.
Conduit: Rigid, Sealtite, or any other suitable tubular connecting means which complies with local ordi-nances and provides adequate mechanical
protection for the wires. Most of the electrical products supplied have an oil-tight construction.
4.
Miscellaneous wiring components such as electrical tape, wire connectors, and terminals, as required.
ILLUSTRATION OF ELECTRICAL SYSTEM ON PART REVOLUTION CLUTCH POWER PRESS
LITERATURE FOLDER
Included with every shipment is a literature folder. This includes installation manuals, Operator Safety Precaution Pamphlet (Part No. KSC-000),
danger sign(s), electrical schematics, and a booklet entitled Mechanical Power Press Safety (Part No. KSL-051). These publications must be
available and fully understood by all appropriate personnel, before any retrofit installation begins. Please notify Rockford Systems immediately if
there are any questions about the components received.
MECHANICAL POWER PRESS SAFETY BOOKLET
A copy of Booklet No. MPPS (Mechanical Power Press Safety) is enclosed. This booklet is copied verbatim from the CFR (Code of Federal Regulations)
and contains all relevant sections of the OSHA regulations concerning power presses with which an employer (user) must comply. The enclosed
equipment must be installed, used and maintained to meet these regulations. Specifically, any time a foot switch is used, a suitable
point-of-operation
safeguard or device must be used
to prevent bodily injury. In addition,
every press must be provided with a point-of-operation safeguard!
Please review this booklet and the appropriate ANSI (American National Standards Institute) safety standard before installing the enclosed equipment.
If you are unfamiliar with these detailed safety regulations, which include regulations on safeguarding the point of operation properly, you may want
to attend our regularly scheduled machine safeguarding seminar. To obtain detailed information about this training seminar, please call, fax, write, or
check our Web site. Our address, telephone, fax number, and Web site address are on the front cover of this manual.
DISCONNECT
SWITCH
MOTOR
STARTER
PRESS
CONTROL
Die Block
Interlock
Foot Switch
Palm Button
Assembly
(If furnished)
(If furnished)
Timing Device
Dual Valve
Air Pressure Switch
Prior Action
(If furnished)
Primary
Voltage
115
208
230
460
575
(If furnished)
(If furnished)
(If furnished)
(Continued on next page.)
