Rockford Systems, LLC.
Call: 1-800-922-7533
11
SSC-1500 Part Revolution Solid-State Control
SECTION 2—INTRODUCTION
Sequence of Operation
(continued)
FOOT SINGLE STROKE
To use
Foot Single Stroke
, the mode selector switch must be set to
SINGLE
, and the actuating means selector switch must be set to
FOOT
.
Foot Single Stroke
is a mode of operation in which the slide makes one complete stroke or cycle upon actuation of the foot switch. The foot switch
must be held depressed during the die-closing portion of the stroke. Once the ram passes this part of the stroke, the foot switch can be released
and the slide will automatically return to the top. If the foot switch is released during the die-closing portion of the stroke, the slide will stop and the
foot switch must be released and then reactuated to finish the stroke.
TWO-HAND “WALK-AWAY” CONTINUOUS
To use
Two-Hand “Walk-Away” Continuous
, the mode selector switch must be set to
CONT
, and the actuating means selector switch must be set
to
HAND
.
Two-Hand “Walk-Away” Continuous
mode allows the press to operate continuously, after initiation, without the operator present. To initiate this
mode, press the prior-action push button then depress the palm buttons. The press will run in the continuous mode until the yellow top-stop button
or the red e-stop button is depressed. The palm buttons must be depressed within five (5) seconds of pressing the prior-action push button. If more
than five (5) seconds elapses, the prior-action push button must be pressed again before the palm buttons are depressed. Please consult the factory
if a prior-action push button is required but was not furnished with the control.
OPTIONAL MODES
Continuous-On-Demand, Foot-Maintained Continuous, Two-Hand-Maintained Continuous, One-Hand or Foot Trip Single Stroke, and Automatic
Single Stroke
are optional modes of operation also provided with the SSC-1500 press control.
These modes of operation are accessed through the
optional modes program screen. See pages 58 - 60 of this installation manual for programming information.
These optional modes (except One-
Hand or Foot Trip Single Stroke
) require the use of a prior-action push button. Please consult the factory if a
prior-action push button is required but was not furnished with the control.
