6.2.2. Center of mass and tool center point
The following table contains Center of mass and TCP for AirPick with and without the available suction cup kits.
Products
Center of mass (mm)
TCP (mm)
Mass
(g)
X
Y
Z
X
Y
Z
AirPick (without suction cups)
-0.5
-9.0
21.0
0.0
0.0
44.7
545
AirPick (with one suction cup)
-0.5
-8.5
23.4
0.0
0.0
76.7
580
AirPick (with two suction cups)
-0.3
-5.1
40.3
0.0
0.0
127.7
955
AirPick (With four suction cups)
-0.2
14.0
45.6
0.0
0.0
127.7
1100
Table 6-4: Center of mass and tool center point matrix.
Info
For TCP and center of mass of the AirPick used in combination with other Robotiq products, please consult the specific
table provided on our
.
The coordinate system used to calculate the moment of inertia and center of mass of the Vacuum Gripper is shown in the figure
below.
Fig. 6-13: Inertia matrix for AirPick Gripper.
88
Содержание AirPick
