RIGO PERFECT BINDER 420 HM, Руководство пользователя

Страница: 41 / 60

41
Tel: +4
5 36173363
, e-mail:
info@rich-ebbesen.dk
7.5 Bookbinding process
If the glue has reached the setted value; instead of “HEATING” text “READY” text
appears, the working process can be started.
The working process is composed of working cycles.
The sequence of a working (or binding) cycle is the following:
- put the document to bind into the carriage clamp (the clamp stays at the left side).
- push the close-forward button to close the carriage
clamp and to start the binding cycle. The closing can
be interrupted and the clamp can be opened by the
pressing of the open-back button. If the operator
leaves his hand in the way of the safety beams the
clamp does not start: “Obstacle in”.
In this case it is possible to open the carriage with
open-back button if any problem would occur.
After removing the hand and the cycle is allowed; the side-gluing wheels and scoring
wheels are set up to the proper value. If the cover feeding is allowed then it happens
too.
- before the carriage would start with the book block the machine measures the
thickness of the book which process is shown by “Setting side g. wheel” text.
- the carriage clamp starts with the book block (or document to bind) to the right
end final position.
- before it reaches the final end position it goes across the milling unit and the glue
tank.
- the milling unit is also slits the book spine if it is setted to a different value than 0.
To adjust the milling height please read the instructions in the section “The working
and actuation of the machine”.