23
25
26
20
22
21
12
16
17
18
13
15
14
11
6
6
7
9
10
2
1
3
8
4
5
24
19
Intended Use
Reasonably predictable Misuse
The intended use of Regent plows includes loosening and turning the
arable soil in the area of the working horizon on agricultural areas
with moderate stone content at moderate speed (<10 km / h).
Plows must be used under normal conditions of use and within the
purpose for which they were developed. Permissible conditions
correspond to operation with sufficient soil moisture (no use on he
-
avily hardened and dry soils, no use in frost / soil frost), operation at
a working depth that is adapted to the soil and body shape and
operation with a towing vehicle in accordance with the permissib
-
le performance class and with sufficient dimensioned hoist.
The intended use requires the exclusive use of original spare parts
and compliance with all operating, maintenance, safety and ac
-
cident prevention regulations prescribed by the manufacturer. In
addition, the generally recognized and country-specific safety
and occupational health regulations must be observed. The road
traffic regulations of the legislator must always be observed for
transport on public areas.
The plow and towing vehicle must be checked for operational sa
-
fety before each use. If a defect is found, the device must never
be put into operation.
Any unauthorized change to the device or the use of parts from
other sources exclude the manufacturer‘s liability for any damage
resulting therefrom.
Components
Plough share
1
Reversible coulter tip
2
Leg holder
3
Skimmer- Mouldboard
4
Skimmer- Share
5
Slide plates
6
Slide plate box
7
Shear bolt
8
Mouldboard tip
9
Deflector plate
10
Camber spindle
11
Linkage tower
12
Turning cylinder
13
Alignment cylinder
14
Cutting width cylinder
15
Support wheel console
16
Support wheel holder (bar)
17
Disc coulter- holding rail
18
Trunk landside
19
Landside
20
Mouldboard strut
21
Skimmer- plug-in holder
22
Support wheel
23
Support wheel- holding rail
24
Disc coulter
25
Landside plate
26
¾
Faulty assembly.
¾
Failure to comply with operating or maintenance instructions.
¾
Operation with heavily worn parts.
¾
Use of unsuitable equipment or non-original spare parts.
¾
Operation with towing vehicles that exceed the permissible
performance class.
¾
Operation on heavily hardened or dry soils.
¾
Operation on soils with obstacles / barriers in the soil (large
stones, rhizomes).
¾
Operation on sites with layers of rock just below the surface or
large stones anchored in the ground.
¾
Operation of power-operated equipment or commissioning of
the towing vehicle despite people in the danger zone.
¾
Driving tight curves during plowing.
¾
Initiation of the turning process when the lifting height is too
low, possibly causing collision with the ground.
¾
Exceeding the max. working depth, the following working
depths are the maximum values for the respective body
shape:
M4
WS7-38
WS7-42
WS7-46
SKL5
SKL5B
SK6
SKK6
WS794
SK10
T62
T65
32 cm
25 cm
28 cm
30 cm
35 cm
45 cm
50 cm
4
www.regent.at
