Reeves G2 series, Руководство по эксплуатации

Страница: 54 / 183

Operation & Maintenance w/IPB G2 Series Decontamination Water Heater 0010
Part Number: 1006375 0010-8 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
Table 1. Operator Troubleshooting – Mechanical (Cont).
ITEM CONDITION/INDICATION POSSIBLE MALFUNCTION CORRECTIVE ACTION
Check the fuel pump.
A) Inspect the fuel pump coupler for
wear (should have 1/8” end play).
B) Open the bleeder valve:
1. If fuel flows freely, fuel pump
may not be turning at correct
RPM or fuel pump may be
defective.
2. If low or no fuel present from
bleeder valve, check for
vacuum leaks between the
fuel pump and the fuel tank.
3. Reset fuel pressure to 140
PSI.
12.
(Cont)
No Hot Water. No heat or flame.
Contact Reeves EMS
Injector Assy (G2-I and
G2S-I Only).
Water flow rate exceeds rated
service flow of injector. Reduce flow rate. 13. No Clicking Sound when
bypass lever is in the ON
position.
Operating pressure exceeds
maximum limit. Install a pressure reducer valve.
Suction tube or suction tube
fitting cracked and leaking. Replace as required.
Clogged Suction Tube Filter. Replace and / or clean as required.
14. Clicking Sound without
Suction of Decon
Solution.
Check valve leaking. Clean and replace as required.
15. Decon Solution Tank. Check Valve Leaking. Check seat area on suction tube
fitting.
Check valve and seal must fit loose in
the suction tube fitting.
Solution pickup is not
completely submerged. Check and submerge if necessary.
Solution strainer obstructed. Inspect, clean and or replace.
Solution hose is cut,
obstructed or kinked. Inspect, clean and or replace.
16.
Decon solution will not
siphon.
Bypass lever is OFF. Turn bypass lever to the ON position.
END OF TASK
END OF WORK PACKAGE