Reeves G2 series, Руководство по эксплуатации

Страница: 51 / 183

Operation & Maintenance w/IPB G2 Series Decontamination Water Heater 0010
Part Number: 1006375 0010-5 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
Table 1. Operator Troubleshooting – Mechanical (Cont).
ITEM CONDITION/INDICATION POSSIBLE MALFUNCTION CORRECTIVE ACTION
Insufficient or improper air
supply or adjustment. Adjust accordingly to the procedures
listed in Maintenance every 3 months.
Fuel nozzle orifice is too
large. Replace with correct nozzle.
Fuel pressure is too high. Check fuel pump discharge pressure.
Contact REEVES EMS.
7.
Burner discharges black
smoke.
Combustion chamber loaded
or restricted with unburned
fuel and / or soot. Entire burner and fuel system needs
cleaning and servicing.
Contact REEVES EMS.
8.
No discharge at
showerheads. Inadequate water supply. Ensure hose is 1 ½” dia. and
incoming water supply is turned on.
9.
Low or fluctuating
pressure. Water inlet hose is kinked. Remove kink.
Check all plumbing
connections. Tighten or repair as necessary.
Restriction of water flow
through heater, which causes
over pressurization. Remove or repair restriction.
Check quality of incoming water
supply.
Remove and inspect inlet screen for
blockage.
Check for scale buildup in
heat exchanger coil. Contact REEVES EMS for de-scaling
procedures.
Water inlet pressure is too
high. Incoming water pressure can not
exceed 125 PSI.
Water output temperature is
too high. Excessive heat can
cause over pressure situation Check temperature control or setting.
10.
Water is leaking from
under heater or from the
Pressure Relief Valve.
Defective pressure relief
valve or valve being left open. Replace pressure relief valve.
(NOTE: NEVER run heater without
the Pressure Relief Valve – may
cause an explosion).