Reeves G2 series, Руководство по эксплуатации

Страница: 95 / 183

Operation & Maintenance w/IPB G2 Series Decontamination Water Heater 0015
Part Number: 1006375 0015-7 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
REMOVE AND REPLACE FUEL PUMP/SOLENOID WORK INPROGRESS
PROCEDURES REQUIRE VERIFICTAION
INITIAL SETUP:
Tools and Special Tools References
General Mechanics Tool Kit
Materials/Parts Equipment Condition
Waste Fuel Container Equipment Powered Down
Rags Power Source Disconnected
Pipe Dope
REMOVAL OF FUEL PUMP / SOLENOID PROCEDURES
1. Removing the fuel pump/solenoid as follows:
a. Disconnect power cord from power supply.
b. Attach drain hose to the fuel water separator bowl drain valve.
c. Open drain valve and drain contents into a waste fuel container.
d. Using a 9/16” open end wrench, loosen and disconnect fuel in-line at fuel water strainer housing.
e. Remove drain hose and retighten drain valve.
f. Using a 9/16” open end wrench, loosen and disconnect fuel line at the fuel pump/solenoid assembly.
g. Using a 7/16” open end wrench, loosen and disconnect the fuel nozzle tube.
h. Disconnect the solenoid electrical harness plug.
i. Using a ½” open end wrench, loosen and remove the fuel pump/solenoid assembly (2) mounting
bolts.
j. Remove fuel pump/solenoid assembly from burner motor housing.
k. If fuel pump/solenoid assembly is being removed and replaced, perform the following steps:
1. Loosen and remove fuel water separator assembly.
2. Using a 5/8” open end wrench, loosen and remove both 90° elbow; remove and discard o-rings.
WARNING
DO NOT USE TEFLON TAPE. Pipe Dope may be applied to the threads of the
fittings.
3. Lubricate and install new o-rings on each 90° elbow; using a 5/8” open end wrench, install and
tighten both elbows.
4. Install and tighten fuel water separator assembly.