Reely 1086094, Руководство по эксплуатации

Страница: 59 / 140

59
Setting Rear Axle Camber:
Set camber more negatively:
Turn both ball-head screws (A) and (B) clockwise.
Set camber more positively:
Turn both ball-head screws (A) and (B) counter-clockwise.
The metal grub screws (C) must not be twisted.
The small hexagon hole of the ball-head screws (A) and (B) is
only visible when looking right through the large hexagon hole of
the metal grub screws (C).
Use a 2 mm-hexagon wrench (D) to twist the ball-head screws
(A) and (B); a 4 mm hexagon wrench (E) is needed for the metal
grub screws (C).
The metal grub screws (C) serve to fasten the ball-head screws
(A) and (B) in the axis spur. Never tighten the grub screws (C)
forcefully. Otherwise, the wheel suspension cannot move freely.
(The grub screws also must not be turned in too loosely either,
however, since the axis stub will otherwise wobble).
Depending on rim build, the rear wheel must be removed to set
the ball-head screws (A) and (B) by first removing the wheel nut
(1) with a suitable wheel but wrench.
The wheel tappet nut (2) may remain in the rim when removing
the rear wheel or detach from the wheel axle (3) when the wheel
is taken off. In this case ensure that the driving pin (4) does not
fall out and gets lost.
When the wheel is later replaced, ensure that the tappet pin (4)
is exactly in the centre of the wheel axle (3) and inserted into the
respective groove of the wheel tappet nut (2).
A
B
C
C
D
E
D
E
1 2
4
3