AH-95-02.4
1 0
1 0
1 0
1 0
1 0
Gun Holder
Gun Holder
Gun Holder
Gun Holder
Gun Holder
-REFER TO FIGURE 2
-REFER TO FIGURE 2
-REFER TO FIGURE 2
-REFER TO FIGURE 2
-REFER TO FIGURE 2
The gun holder (item 74) is bar designed to be
bolted to a vertical surface (i.e., workbench,
etc.). The hollow gun handle fits over the bar for
holding the handgun when the gun is not being
used.
After attaching the gun holder to the fixture, the
bar should be adjusted so that the handgun sits
at approximately a 15
o
angle downward. This
prevents paint and/or solvent from running back
onto the gun.
No. 2 Process Handgun
No. 2 Process Handgun
No. 2 Process Handgun
No. 2 Process Handgun
No. 2 Process Handgun
-REFER TO FIGURES 2, 3, 4, & 12
-REFER TO FIGURES 2, 3, 4, & 12
-REFER TO FIGURES 2, 3, 4, & 12
-REFER TO FIGURES 2, 3, 4, & 12
-REFER TO FIGURES 2, 3, 4, & 12
Once the power supply has been properly in-
stalled and wired, the No. 2 handgun can be in-
stalled.
1.
Insert 1/2 to 1 ounce of dielectric oil
(item 84) into the high voltage cable re-
ceptacle inside the power supply.
2.
Install and secure the high voltage cable
to the power supply.
3.
Install hose fitting on the fluid hose as
shown in Figure 3.
Ensure oil is directed ONLY into white
high voltage tube.
N O T E
N O T E
N O T E
N O T E
N O T E
Ransburg supplies a standard 25 foot
hose. Optional hose lengths of 36, 50, 75,
and 100 feet are available. To meet vari-
ous length requirements, the hose fitting on
one end has not been attached.
N O T E
N O T E
N O T E
N O T E
N O T E
Figure 3: Line Fitting Installation
Figure 3: Line Fitting Installation
Figure 3: Line Fitting Installation
Figure 3: Line Fitting Installation
Figure 3: Line Fitting Installation
4.
Connect filter assembly (item 80) to
hose connector assembly (item 65).
Connect fluid line assembly (item 71) to
the filter assembly. Connect the oppo-
site end of fluid line assembly to the
paint source. An adapter (item 72) is
supplied for the fluid line assembly if it
is required. This adapter connects to a
3/8"-16 NPS male fitting.
Determine the hose length that is needed
and cut the hose. Attach the other fitting as
follows:
1. Lubricate all fittings with dielectric grease
(item 83).
2. Screw ferrule counterclockwise onto hose
until it bottoms, then back it off 1/8 of an
inch.
3. Install nut over union stem and start the
stem into the hose.
4. Using the 3/16-inch Allen wrench, screw
the union stem into the hose until it bot-
toms against the ferrule.
Содержание 19372
Страница 4: ...AH 95 02 4...
Страница 61: ...AH 95 02 4 NOTES NOTES NOTES NOTES NOTES...
Страница 62: ...AH 95 02 4 NOTES NOTES NOTES NOTES NOTES...