AH-95-02.4
1 2
1 2
1 2
1 2
1 2
No. 2 Handgun Brush
No. 2 Handgun Brush
No. 2 Handgun Brush
No. 2 Handgun Brush
No. 2 Handgun Brush
Positioning and Wear
Positioning and Wear
Positioning and Wear
Positioning and Wear
Positioning and Wear
-REFER TO FIGURE 4
-REFER TO FIGURE 4
-REFER TO FIGURE 4
-REFER TO FIGURE 4
-REFER TO FIGURE 4
When installing the electrical contact brush (P/N
3695-00), it is important that it is properly posi-
tioned to provide LIGHT CONTACT
LIGHT CONTACT
LIGHT CONTACT
LIGHT CONTACT
LIGHT CONTACT with the
bell conductive coating. Excessive contact
pressure from the contact brush will wear away
the conductive coating or the brush tip, causing
poor electrical contact. The small plastic pad at
the tip of the brush arm should lightly contact
the black bell coating, not the wire
not the wire
not the wire
not the wire
not the wire. The tip of
the brush should not extend past the edge of the
bell cup or into the radius at the edge (see Fig-
ure 4). The brush should normally have a slight
When the radius portion of the plastic
tip is gone, this is equal to one-half of the
brush tip.
N O T E
N O T E
N O T E
N O T E
N O T E
curve to the arm. The more pressure applied
the lesser the curve (see Figure 4). The tip of
the brush assembly must be inspected prior to
each use for wear. When one-half (1/2) of the
plastic tip is worn away the brush assembly
should be replaced (see Figure 4).
Figure 4: Feed Tube and Brush Positioning
Figure 4: Feed Tube and Brush Positioning
Figure 4: Feed Tube and Brush Positioning
Figure 4: Feed Tube and Brush Positioning
Figure 4: Feed Tube and Brush Positioning
BRUSH
CONTACT AREA
CONTACT POSITION
UN-INSTALLED BRUSH SHAPE
1/4" TO 1/2"
FEED TUBE AND BRUSH CONTACT POSITIONING
GOOD TIP
WORN TIP
Содержание 19372
Страница 4: ...AH 95 02 4...
Страница 61: ...AH 95 02 4 NOTES NOTES NOTES NOTES NOTES...
Страница 62: ...AH 95 02 4 NOTES NOTES NOTES NOTES NOTES...