Chapter 3 On-board Remote Management
Commands Page
Quantum SuperLoader 3A Series User’s Guide
47
Performing a System
Reset
3
You will use
System Reset
when making mode changes, magazine
changes, and IP address changes. A system reset will take at least three
minutes if there is a tape in the drive, or approximately 30 seconds
otherwise. To perform a system reset:
1
From any page, click the
Diagnostics
heading. The
Diagnostics
screen
displays.
2
Under the
System Reset
section, click
System Reset
.
Commands Page
You can move tapes, run a system inventory, or reset the picker to its
home position from the
Commands
page. When you click
Commands
, the
page displays.
Moving Tapes
3
From a remote location, you can request that a tape be moved from one
position to another. To move a tape:
1
From any page, click the
Commands
heading. The
Commands
screen
displays.
2
From the
Moving Tapes
section of the page, click the drop-down
menu under
From:
and select the current location of the tape that you
want to move.
3
From the drop-down menu
under
To:
, select the location to which
you want to move the tape, and then click
submit
.
Note:
You can also click the slot on the graphic of the autoloader
magazine to select and move a cartridge.