Quantum Scalar i40, Руководство пользователя

Страница: 33 / 328

Chapter 1: Description
Library Components
Quantum Scalar i40 and Scalar i80 User’s Guide 7
Power Supply
The Scalar i40 and Scalar i80 libraries support single power
configurations consisting of a single AC line input and single DC power
supply. The Scalar i80 library supports a redundant power configuration
consisting of a dual AC line input and dual DC power supplies.
If you have a Scalar i80 and are only using one power supply, the power
supply should be installed in the upper power supply slot, and a filler
plate must cover the empty power supply slot (see Figure 5 on page 9).
If you are using redundant power, you can hot add or hot swap a power
supply (power to the library remains on while you add or exchange the
hardware).
The Scalar i40 power supply cannot be installed in a Scalar i80. However,
the Scalar i80 power supply works in either the Scalar i40 or the
Scalar i80.
Warning: The power outlet must be available near the library and
must be easily accessible.
The power system consists of the following components:
• Power supply
• AC power cord
The power supply has one status LED. For more information, see Power
Supply LED on page 255.
For information on removing and replacing power supplies, see
Removing and Installing a Power Supply on page 220.
System Control Board
The system control board (SCB) contains the library firmware and
processor. It manages the entire library, including the operator panel
and robot, and is responsible for running system tests to ensure that the
library is functioning properly. The SCB has two Ethernet ports:
• Left port — for remote management (Web client)
• Right port — for service only. In rare cases, you may need to change
the IP address of the port if it conflicts with your library IP address
(see Configuring the Service Port on page 77).
See Figure 4 on page 9 and Figure 5 on page 9 for port locations.