Quantum Scalar i40, Руководство пользователя

Страница: 47 / 328

Chapter 2: Initial Installation and Setup
Turning the Library ON and Configuring Network Settings
Quantum Scalar i40 and Scalar i80 User’s Guide 21
Remember that you can always change the configuration later if
needed.
• To cancel out of the Setup Wizard and begin using the library
immediately, press the button below
Cancel
on the menu bar.
This accepts the library’s default configuration, including an
IPv4 address assigned by DHCP (see Default Configuration on
page 42). You can change any of the configuration settings later
using the Setup menus on the operator panel or the Web client.
It is easier to configure the library using the Web client, so you
may wish to cancel now. To access the Web client immediately,
skip the rest of this section and go to Accessing the Library Via
the Web Client on page 25.
5 The Setup Date/Time screen appears (see Figure 11 ).
Figure 11 Setup Wizard –
Date/Time Screen
Do one of the following:
• To accept the date and time, press the Accept button.
• To change the date or time, press the Change button. The Date
field becomes available to edit and the menu bar button
designations change. Use the
Left and Right buttons to move
through the date field, one digit at a time. Use the Up and
Down buttons to change each digit of the date value. As you
press Right , each digit of the date fills in. Continue to press the
Right button to go to the Time field and edit it the same way.
See Figure 12 . When you reach the last digit of the Time field,
the Right button designation changes to Apply . Press the Apply
button. The new date and time display, and you can Accept or
Change . Once you press Accept , you move to the next step.