Quantum Scalar i40, Руководство пользователя

Страница: 104 / 328

Chapter 4: Configuring the Library
Working With Local User Accounts
78 Quantum Scalar i40 and Scalar i80 User’s Guide
You should not need to change the service port subnet unless it
happens to conflict with the subnet configured for the customer port. If
there is a conflict you must change it to avoid ambiguity between the
two interfaces.
The instructions below explain how to change the IP address on the
service port. You can only change the subnet (third octet) of the IP
address: 192.168.
xxx
.1. The other sections must remain as they are. You
may choose a number from 1 to 255.
You can only configure the service network from the operator panel.
Operator Panel
1 Select Tools > Service Network .
Under “Modify Subnet” the first digit of the three-digit octet of the
IP address is highlighted.
2
Use the
Left
and
Right
buttons to select a digit to modify. Use the
Up and Down buttons to select a value for the digit. When you
press the Right button to the third digit, its function changes to
Apply
.
3 When you finish making changes, press the Right button until its
function changes to Apply , then press Apply .
4 Press OK .
5 Save the library configuration (see Saving the Library Configuration
on page 101).
Working With Local User Accounts
Administrative users can create and modify two types of local user
accounts: user and administrative user. These users have different library
privilege levels and can access different things. The Web client requires
user accounts and user logins; the operator panel does not. You can
configure the operator panel to run with no logins required. You can
also configure the library to use Lightweight Directory Access Protocol
(LDAP) accounts.