QuadTech 1865, Инструкция по эксплуатации, Страница: 62 / 87

Page 62 of 87 Operation
Table 2-5: IEEE and RS-232 Commands
Command
Function Parameter(s)
CONFigure:
VALid? Is filename valid to save? xxxxxxxx
SAVe:
DUPLicate Save setup as duplicate filename in battery
backed up RAM xxxxxxxx
NEW Save setup as new filename in battery
backed up RAM xxxxxxxx
RECall filename Recall setup filename from battery xxxxxxxx
backed up RAM
FVALid? Is filename valid to save? xxxxxxxx
FSAVe:
DUPLicate
Save setup as duplicate filename on floppy xxxxxxxx
NEW Save setup as new filename on floppy xxxxxxxx
FRECall filename Recall setup filename from floppy drive xxxxxxxx
HANDler (state) Turn handler port OFF or ON 0 (OFF) 1 (ON)
VOLTage value Set the voltage to value 0000.000
TCHarge value Set the charge time to value 000
TDWell value Set the dwell time to value 000
TMEasure value Set the measure time to value 000
TDIScharge value Set the discharge time to value 000
MODE Set the mode to A (Auto) M (Manual)
RANGe Set the range to Auto 1mA 100uA
10uA 1uA 100nA
10nA 1nA
AVERage Set # to average 000
LIMit value Set the limit to value floating point number
FRESult Set the result format to S (Scientific)
E (Engineering)
DISPlay type Set display type to R (Resistance)
I (Current)
P (Pass/Fail)
N (No Display)
SONPass Stop on pass 000
RVALid? Is results filename valid? xxxxxxxx
RTOFloppy: Results to floppy
DUPLicate Save results as duplicate filename on floppy xxxxxxxx
NEW Save results as new filename on floppy xxxxxxxx
APPend Append results to existing filename xxxxxxxx
CLOSe Close results of filename xxxxxxxx